Above is the wing as I received it - Below is the other side in my shop after getting it home  

Above is the wing with fuel bays closed (As I received it) This will need to be removed to make some corrections -

Same side of wing as above with fuel bay skins removed to make corrections (I will take this opportunity to add a fuel cell in each wing)  

The above pictures are from after Scott's visit to check out the project. 12-28-2009 - The horizontal stabilizer in the middle picture was built incorrectly by the original builder and is being re-fabricated.  

The above pictures are from Scott's second visit. We laid up the skins and rear spar for the new horizontal stabilizer and attached the rudder upright.

On the far right - Using 2X4's stacked 2 tall to help preset the skins curve.  

  The HS rear spar and rough cut ribs

 The HS spar cut to size (On top of the post cure oven)